Banach空间Fuzzy多值隐拟变分包含

在Banach空间中并在不具紧性的条件下，引入和研究了一类fuzzy多值隐拟变分包含及相应的fuzzy隐预解算子方程，借助预解算子技巧，建立了Banach空间中fuzzy多值隐拟变分包含与预解算子方程的等价性，得到了该类fuzzy多值隐拟变分包含的迭代算法与某些解的存在性定理及解的迭代逼近。     

Reduction of low-frequency pressure fluctuations in wind tunnels

The determination of dynamic wind loads on buildings, i.e. pressure and deflection, has gained increasing interest (European Prestandard ENV 1991-2-4, Eurocode 1: basis of design and actions on structures—Part 2-4: actions on structures—wind actions, European Committe for Standardization, Brussels, 1995; DIN 1055 Teil 4 Lastannahmen für Bauten, Verkehrslasten, Windlasten bei nicht schwingungsanfälligen Bauwerken, 1991; N. Hölscher, M. Hortmanns, J. Sahlem, Praxisnahe Erfassung von Windwirkung an Industrie- und Hochbauten, Windwirkung im Bauwesen, Braunschweig, 7, Dreiländertagung D-A-CH 2001, Windtechnologische Gesselschaft, 2001 [1], [2] and [3]). Therefore, the spectral distributions of velocity and pressure fluctuations in wind tunnels are an important quality aspect. While velocity fluctuations can be manipulated by the obstacles used to create the turbulence, pressure fluctuations are influenced by acoustic noise as well. Especially, the first eigenfrequency of the longitudinal mode of the wind tunnel tends to disturb the pressure spectrum.In this paper, a solution for the reduction of low-frequency acoustic pressure fluctuation is presented and its application in the atmospheric boundary layer wind tunnel at the IAG is shown.     

有机电沉积涂料的新动向

阴极电沉积涂料是 2 0世纪 70年代以来发展起来的一种新的涂装方法 ,具有挥发性有机物 (VOCs)和有害空气污染物(HAPs)含量低、防蚀能力强、漆膜质量好、涂料利用率高、适合涂装结构复杂的构件和设备等特点。介绍了近年来阴极电沉积涂料研发的新动向。它们主要集中在有机双层电涂和高分子 聚电解质 /低聚物电解质复合物多层电涂体系 ,这些新的电涂体系在涂料的稳定性以及涂层的物理化学性质和力学性能方面具有明显的改进。     

长输管道外防护层的选择与应用

文章介绍了目前国内外长输管道外防护技术的特点和防护层应用的现状,分析了常用防腐蚀材料的防腐蚀性能。指出在山区复杂地形条件下,应考虑环境条件和施工条件,并通过技术经济分析对管道外防腐蚀层进行合理选择。     

硅外延片中的杂质控制

有5类掺杂源影响硅的外延片中的杂质分布。主掺杂质控制外延层的杂质浓度，决定外延层的电阻率。固态外扩散、气相自掺杂和系统自掺杂影响衬底界面附近的外延层杂质浓度的深度分布。该文介绍了此3类掺杂源的掺杂过程和抑制方法。金属杂质在外延层中对器件有害，防止沾污和使用吸杂技术能降低金属杂质在外延层中的浓度。     

The Adhesion and Formation Mechanism of Blast Furnace Gunning Layer

1 Introduction Gunning refractories are unshaped refractories commonly used in iron and steel industry for the main- tenance of furnace linings. The specific way of gunning processing requires the refractory to have specific rheo- logical properties so as…     

考虑界面层时纤维脱粘和拔出的数值分析

 纤维增强复合材料的损伤破坏过程包含着基体的损伤和界面的损伤，界面的损伤情况可用界面脱粘长度与纤维的拉拔位移的关系来描述。采用有限元方法，将纤维与基体间的界面视为具有一定厚度的薄层，考虑纤维与基体间的复合效应，针对界面层取不同的材料特性参数或不同的厚度，深入探讨了纤维拉拔荷载和纤维最大位移随界面脱粘长度的变化关系。可为进一步研究界面损伤提供理论基础。     

Homogenization of hardness distribution and distortion in high pressure gas quenching

Quenching with gases rather than oil or other liquid media has the advantages of reducing the risks concerning health and environment, while simultaneously homogenizing the quenching results and minimizing distortion due to a wide range of possible process parameter variations and the pure convective heat transfer. In this contribution, a coupled solution for increasing homogenization of quenching results within high pressure gas quenching will be presented. In the first stage, an experimental test facility was set up for flow investigations and in the second stage a numerical simulation model was generated. The numerical and experimental results of the flow through the chamber were compared for several boundary conditions. Finally, after complete verification of the simulation, the model may be used to assist in parameter variation for optimization of homogeneous high pressure gas quenching.     

Efficient return algorithms for associated plasticity with multiple yield planes

A new return method for implicit integration of linear isotropic yield criteria is presented. The basic idea is to perform all the manipulations in the principal stress space and thereby achieve very simple formulae for calculating the plastic corrector stresses, based on the constant gradient of such criteria. The return formulae are in closed form and no iteration is required. The method accounts for three types of stress return: return to a single yield plane, to a discontinuity line at the intersection of two yield planes and to a discontinuity point at the intersection between three or more yield planes. The infinitesimal and the consistent elastoplastic constitutive matrix are calculated for each type of stress return, as are the conditions to ascertain which type of return is required. The method is exemplified with the Mohr–Coulomb yield criterion. Copyright © 2005 John Wiley & Sons, Ltd.     

黄河流域多沙粗沙区植被覆盖变化与减水减沙效益分析

通过遥感手段和数字流域模型,研究了黄河流域多沙粗沙区近10来年的植被覆盖变化及其减水减沙效益。研究表明,多沙粗沙区90年代末期与80年代末期相比,植被覆盖度增加区域大约占50%,植被覆盖度没变化区域约占48%。植被覆盖度的变化导致了流域水沙条件的变化,90年代末期植被覆盖条件下,植被措施的减水减沙百分比不高;不同的降雨过程,植被措施的减水减沙效益有一定的差别;从不同降雨过程多年平均看,近10来年植被措施年均减水2.63亿m3,减沙1.13亿t,减水减沙比为2.75,即减1亿t沙的同时减水2.75亿m3,减水百分比为7.61,减沙百分比为10.56,减沙效益大于减水效益。